atrinelectronic@gmail.com تهران پاساژ امجد طبقه1 واحد 16

ماژول کوره القای Mini ZVS اورجینال

ماژول کوره القای Mini ZVS دارای حداکثر توان خروجی 120W می باشد
244,000 تومان
2.7 %
237,300 تومان
5.5 %
230,500 تومان
8.3 %
223,700 تومان
توجه: حداقل تعداد خرید این محصول 1 عدد می باشد.
پکیج: Module وزن: 115.0g ابعاد: 1.6x5.5x3.7
دسته بندی اصلی: ماژول و سنسور ها

نقد و بررسی اجمالی

ماژول کوره القای Mini ZVS دارای حداکثر توان خروجی 120W می باشد


(the maximum power of 150W (12V induction heating Push the ignition coil 12V, when the primary 5 + 5 turns, 30W or so
the input voltage DC 5V ~ 12V (5V voltage exceeds 12V or lower than the seller is not guaranteed to work properly, the input voltage is not within this range, a problem the seller is not liable
 Make sure that all components soldered correctly, the power line is not reversed negative, then power
Input voltage: 5v-15v
 (Module dimensions: 5.5 x 3.7 x1.6 cm(L*W*H
Coil size: length:7.5cm
width: 2.8cm
:Package Included
1 x induction heating power supply module
1 x coil
When using battery and battery power supply, it must be ensured that the working voltage is above 4.5V! Do not ensure that the voltage is always above 4.5V during operation, do not use battery or battery power supply! Do not use dry battery power
The width of the heated object should be between 1/3 and 1/2 of the inner diameter of the heating coil, and the maximum should not exceed 2/3
The diameter of the heated object should be controlled within 20mm as much as possible. If the heating is too large, it will be difficult to heat up to red. After all, the power is limited
Inductive heating, usually work for 5 minutes to power off cooling. Because the current is relatively large during induction heating, the coil heat is also relatively large. When heated, part of the heat generated by the heated object is transmitted to the heating coil. For a long time, the temperature of the heating coil is high. If the heating coil is connected to the terminal, the plastic part of the terminal will be melted! Therefore, it is best to solder the heating coil directly to the PCB during induction heating
For long-term use, it is recommended to use a copper tube as a coil and cool it with water
Blue LED power indicator, there is no electricity, you can see if the light is off
The reasons why the indicator light is off may be: 1. The line is not connected, and the power supply is not powered. 2. The board has component damage
When the indicator light is dark, it should be that the power supply is insufficient and you need to replace the power supply with a larger power
- Due to lighting effects, monitor's brightness , contrast settings etc, there could be some slight differences in the color tone of the pictures and the actual item Please allow 1-2mm differs due to manual measurement, thanks

به سبد خرید اضافه شد.
سبد خرید
Item removed. بازگرداندن