02166766927 -02166703652
info@atrinelec.com تهران پاساژ امجد طبقه1 واحد 16
نام قطعه
ماژول SHT30
نام کامل قطعه
SHT30 اندازه گیری دما و رطوبت
پکیج
MODULE
طول
2 cm
عرض
3 cm
دیتا شیت
تعداد
قیمت فروش
+1
91,800 تومان 74,500 تومان
+5
86,400 تومان 70,200 تومان
+15
81,000 تومان 65,800 تومان
موجودی:
0
اورجینال
توجه: حداقل تعداد خرید این محصول 1 عدد می باشد.

ماژول سنسور اندازه گیری دما و رطوبت با رابط I2C،دوسیمه Temperature Humidity Sensor Accuracy

 

 دریافت دیتا شیت

Sensiron Temperature/Humidity sensors are some of the finest & highest-accuracy devices you can get. And, finally we have some that have a true I2C interface for easy reading. The SHT30-D sensor has an excellent ±2% relative humidity and ±0.3°C accuracy for most uses

Unlike earlier SHT sensors, this sensor has a true I2C interface, and (bonus!) even with two address options. It also is 3V or 5V compliant, so you can power and communicate with it using just about any microcontroller or microcomputer

Such a lovely chip - so we spun up a breakout board with the SHT30-D and some supporting circuitry such as pullup resistors and capacitors. Each order comes with one fully assembled and tested PCB breakout and a small piece of header. You'll need to solder the header onto the PCB but it's fairly easy and takes only a few minutes even for a beginner

Power Pins

Vin - this is the power pin. The chip can use 2.5-5VDC for power. To power the board, give it the same power as the logic level of your microcontroller - e.g. for a 5V micro like Arduino, use 5V. For a 3.3V controller like a Raspbery Pi, connect to 3.3V

GND - common ground for power and logic

 

I2C Logic pins

SCL - I2C clock pin, connect to your microcontrollers I2C clock line

This pin has a 10K pullup resistor to Vin

SDA - I2C data pin, connect to your microcontrollers I2C data line

This pin has a 10K pullup resistor to Vin

 

Other Pins

ADR - This is the I2C address selection pin. This pin has a 10K pull down resistor to make the default I2C address 0x44. You can tie this pin to Vin to make the address 0x45
RST - Hardware reset pint. Has a 10K pullup on it to make the chip active by default. Connect to ground to do a hardware reset
ALR - Alert/Interrupt output. You can set up the sensor to alert you when an event has occured. Check the datasheet for how you can set up the alerts

به سبد خرید اضافه شد.
سبد خرید
سبد خرید
Item removed. بازگرداندن
اغاز کار